Raleri Fogstop Helmet Insert – Clear

Description

Raleri Antifog insert helps to make your helmet visor anti-fog. This helmet insert can be used at both the times during day and night.

• Anti-fog with clear view
• Made in Italy
• 100% optically correct with no visual distortion
• High quality special sealing gasket
• Fits almost all helmets without pins

*NOTE: Incase your visor has Pinlock pins please download the template & check if the insert fits your helmet visor.

Raleri Fogstop Installation Procedure:

1. Download the template, print it at 100% scale and cut according to the size.
2. Tape the paper template on outside of visor using cello-tape. Align it properly so that its in the center (vertically as well as horizontally)
3. Remove the visor from helmet and neatly clean the inside of the helmet
4. Remove the white tape on one side of the Raleri insert.
5. Using the paper template as a marker, gently stick the insert from one side of the visor. Do not press the insert to much
6. Check if the insert is properly aligned. If not, then you can remove and start again.
7. Once properly installed, run your finger all along the glue to ensure there are no air bubbles and the insert is sealed from all sides.
8. Remove the protective plastic cover and install the visor on the helmet.

Tried & tested on below models:

Bell MX9, Bell Qualifier, Scorpion EXO series, AGV K1 & K3, Schuberth C4, RE Escapade

MT helmets V12 visors – MT Mugello, Upto 2019 Stinger, MT Thunder & MT 2016 Blade Helmets.

MT helmets with V14 visors – MT Hummer, MT Targo,MT Blade2, MT Revenge2 & MT Rapide helmets

NHK – GPRTech

*To be installed once only, if removed cannot be re-applied.

Weight – 0.2 Kg

Dimentions 35 x 15 x 5